CLI Commands
4.1 A
SCALANCE W1750D CLI
54 Function Manual, 03/2019, C79000-G8976-C452-04
<interval>
Configures the report interval of VBR on each
0 - 3600 30
Configures the timeout interval during which
non- target AP will not respond to a specific
1 - 255 10
Configures a balancing strategy for client
match. The applicable values are:
• 1 - Channel-based
• 2 - Radio-based
• 3 - Channel and Radio based
1 - 3 1
The snr value of the Client RSSI must be
higher than the current AP for a potential
0 - 100 10
Denotes the the aging time for stable
1 - 3600 300
threshold <percent>
Configures the minimum percentage of errors
in the channel that triggers a channel change.
0 - 100 70
time <secs>
Configures the time that the error rate has to
be at least equal to the error rate threshold to
trigger a channel change. The error rate must
be equal to or more than the error rate
threshold to trigger a channel change.
1 - 3600 90
<idx>
Checks the difference in threshold in the
channel interference index between the new
channel and the existing channel. An AP will
only move to a new channel if the new chan-
nel has a lower interference index value than
the current channel. This parameter specifies
the required difference between the two inter-
ferenc e index values before the AP moves to
the new channel. The lower this value, the
more likely it is that the AP will move to the
— 25
Configures 2.4 GHz channels. — —
index
Specifies the ideal coverage index that an AP
tries
to achieve on its channel. The denser the
AP deployment, the lower this value should
2 - 20 10
er>
Sets the highest transmit power levels for the
AP. If the maximum transmission EIRP
configured on an AP is not supported by the
AP model, the value is reduced to the highest
supported power setting.
Higher power level settings may be
constrained by local regulatory requirements
0 - 127dBm 127
To Next Page
Loading...
