Siemens SCALANCE W1750D CLI - Page 710

CLI Commands
4.20 W
SCALANCE W1750D CLI
710 Function Manual, 03/2019, C79000-G8976-C452-04
shutdown
spanning-tree
speed <speed>
storm-control-broadcast
storm-control-threshold <threshold>
switchport-mode <mode>
trusted
type <type>
uplink-enable
use-ip-for-calling-station
no wired-port-profile <port>
Parameter
Description
Range
Default
wired-port-profile
<port>
Creates a wired profile. — —
access-rule-name <name>
Maps the already configured access
rules with the wired profile.
— —
allowed-vlan <vlan>
Configures a list of allowed VLANs.
The Allowed VLAN refers to the VLANs
carried by the port in Access mode.
You can configure the list of comma
separated digits or ranges 1,2,5 or 1-4,
or all.
— —
auth-server <name>
Configures the authentication server
for the wired profile.
— —
auto-recovery
Enables automatic recovery of the port
in the AP that is shut down because of
loop protection. After the automatic
recovery, if the loop reoccurs, then the
port is shutdown again.
— Disabled
auto-recovery-interval
<interval>
Specify the time, in seconds, to auto-
matically recover the port in the AP that
is shut down because of loop protec-
tion.
30– 43200
seconds
300 seconds