Siemens SCALANCE W1750D CLI - Page 711

CLI Commands
4.20 W
SCALANCE W1750D CLI
Function Manual, 03/2019, C79000-G8976-C452-04
711
Parameter
Description
Range
Default
called-station-id
{type{ap-group|apname|
ipaddr|macaddr|vlan-id
Configures the following called- station-
id types:
•
ap-group
— The Virtual Controller
name is used as thecalled- station-
id.
•
ap-name
— The AP hostname is
used as thecalled- station-id.
•
vlan-id
— The VLAN ID of the client
is used as the called-station-id.
•
ipaddr
— TheIP addres s of the AP
is used as thecalled- station-id.
•
macaddr
— The MAC add ress of
the AP is used as the calling- sta-
tion-id.
•
vlan-id
— The VLAN ID of the client
is used as the called-station-id
— calledstation-
id {type
<macadd r>}
captive-
portal{<type>[exclude-
uplink <types>]|external
[exclude-
uplink <types>|
profile
<name>[exclude-uplink
<types>]]}
Enables internal orexternal captive
portal authenticatio n for the wired
profile users.You can also disable
redirection to the captive portal based
on the type of current uplink.If the ex-
ternal captive profiles are created, you
can specify the profile name by using
the
external
and
profile
keywords and
associated parameters.
— —
content-filtering
Enables content filtering.
—
—
dot1x
Enables 802.11X authentication for the
Wired profile users.
— Disabled
dot1x-timer-idrequest-
period
Interval in seconds, 802.1X identity
request retries.
— —
dot3bz
Enables 802.3bz authenticatio n for the
wired profile users.
— Disabled
duplex <duplex>
Assigns a value for duplexing client
traffic based on the capabilities of the
client, the AP, and the cable. You can
specify full, half, or auto.
full, half, auto auto
inactivity-timeout <in-
terval>
Configures a timeout value for the
inactive client sessions.
When a client session is inactive for
the specified duration, the session
expires and the clients are required to
log in again.
60-86400
seconds
1000 sec-
onds
l2-auth-failthrough
Allows the clients to use 802.1X au-
thentication when MAC authentication
fails.
— Disabled
loop-detection-interval
<interval>
Specify the time, in seconds, to send
loop detection packets on the ports of
an AP.
1–10 sec-
onds
2 second s