Siemens SCALANCE W1750D CLI - Page 712

CLI Commands
4.20 W
SCALANCE W1750D CLI
712 Function Manual, 03/2019, C79000-G8976-C452-04
Parameter
Description
Range
Default
loop-protect
Enables loopprotection on the ports of
an AP.
— Disabled
mac-authentication
Enables MAC authentication. — Disabled
native-vlan <vlan>
Configures a value for Native VLAN. A
VLAN that does not have a VLAN ID
tag in the frames is referred to as Na-
tive VLAN.
1-4093 —
poe
Enables power over Ethernet
—
Enabled
radius-accounting
Enables accounting for the RADIUS
server authentication.
When enabled, the APs post account-
ing information to the Radius server at
the specified accounting interval.
— —
radius-accounting-mode
{user- association|user-
authentication}
Configures an accounting mode for the
captive portal users. You can configure
any of the following modes for account-
ing:
•
user-authentication
— when con-
figured, the accounting starts only
after client authentication is suc-
cessful and stops when the client
logs out of the network.
•
user-association
— When config-
ured, the accounting starts when
the client associates to the network
successfully and stops when the
client is disconnected.
— user- authen-
tication
radius-interim-
accounting- interval
<minutes>
Configures an interval for posting ac-
counting information as RADIUS
INTERIM accounting records to the
RADIUS server.
When configured, the AP sends inter-
im- update messages with current user
statistics to the RADIUS server at regu-
lar intervals.
0–60 —
radius-reauth-interval
<minutes>
Configures a reauthentication interval
at which all associated and authenti-
cated clients must be reauthenticated.
0–32768 —
server-load-balancing
Enables load balancing across two
RADIUS servers if two authentication
servers are configured for the SSID.
— Enabled