August, 2006 COMMON REMOVAL PROCEDURES
3-19
8. Slowly and carefully pull the image transfer unit [A] out of the machine.
Important!
• Remove carefully. The image
transfer unit is heavy and not
attached to the rails with screws.
• To prevent toner scattering inside
and outside the unit, keep the unit [B]
flat when you remove it, lift it, carry it,
and put it down.
• Never stand the image transfer unit
[C] on its edge before you remove
the cleaning unit from the ITB (
3.8.1).
• Never place the image transfer unit
on a carpet where toner may scatter
or the unit will collect dust.
Reinstallation
• Re-insert the image transfer unit slowly and carefully to avoid snagging the belt
on the frame of the machine.
• Make sure that the image transfer unit does not snag on the toner cap of the
yellow PCU on the far left.
1
B132R309.WMF
B132R309B.WMF
[A]
To Next Page
Loading...
