Toshiba e-STUDIO4500c - Image Transfer Unit

COMMON REMOVAL PROCEDURES August, 2006
3-18
3.2.8 IMAGE TRANSFER UNIT
1. Cover the floor or a table with paper to prepare a place to put the image
transfer unit.
2. Open the front door.
3. Remove the toner hopper then push the hopper rails into the machine.
(3.2.7)
4. Rotate the transfer belt release lever [A] counter-clockwise until it stops.
5. Disconnect the fan connector [B].
6. Remove the face plate [C] ( x1,  x5).
7. Rotate the lever B2 [D] on the drawer unit counter-clockwise to separate the
transfer roller from the ITB.
B132R201.WMF
[D]
[A]
[C]
[B]