ADDITIONAL INFORMATIONS April 2007
4-112
4.4.14 NIP WIDTH ADJUSTMENT
This chapter shows you how to measure and adjust the nip width.
Important:
If a finisher is installed on the machine, remove it before you begin these
procedures.
MEASURING THE NIP WIDTH:
1. Load one OHP sheet (“3M PP2500 Transparency Film”) in the bypass tray.
2. Turn OFF “Paper Type Detect “ and “Double Feed Detect” for the bypass tray.
3. Make sure the following SP modes are set to their defaults.
Sp1111-002 (Stop Time) Default: 60
Sp1111-003 (Stop Interval) Default: 200
4. Do Sp1111-001 (Nip Width Mode – Execute).
07/04
To Next Page
Loading...
