Toshiba e-STUDIO4500c - Finisher Jam Detection

August 2006 FINISHER JAM DETECTION
B700-69
Peripherals
2.12 FINISHER JAM DETECTION
Display Mode Jam What It Means
Finisher
entrance
sensor late
After main machine exit sensor goes OFF,
finisher entrance sensor does not go ON even
after enough time to feed 450 mm.
R1 to R3
Proof
Shift
Staple
Finisher
entrance
sensor lag
After finisher entrance sensor goes ON, it does
not go OFF after enough time to feed a sheet 1.5
times its length has elapsed.
Proof exit
sensor late
After finisher entrance sensor goes ON, proof
exit sensor does not go ON even after enough
time to feed 450 mm.
R3 Proof
Proof exit
sensor lag
After finisher entrance sensor goes OFF, proof
exit sensor does not go OFF even after enough
time to feed 450 mm.
Upper tray exit
sensor late
After finisher entrance sensor goes ON, upper
tray exit sensor does not go ON even after
enough time to feed 485 mm.
R4 Shift
Upper tray exit
sensor lag
After finisher entrance sensor goes OFF, upper
tray exit sensor does not go OFF even after
enough time to feed 650 mm.
R8 to R12
R1 to R4
R5 to R7
B700D996.WMF