FINISHER JAM DETECTION August 2006
B700-70
Display Mode Jam What It Means
Pre-stack tray
exit sensor lag
After finisher entrance sensor goes ON, pre-
stack tray exit sensor does not go ON even after
enough time to feed 650 mm.
R5 to R7
After finisher entrance sensor goes ON, pre-
stack tray exit sensor does not go OFF even after
enough time to feed 1650 mm.
Fold unit
entrance
sensor late
(S26)
The fold unit entrance sensor goes not go ON
after enough time has elapsed to feed 1.5 times
the length of the stack after the leading edge of
the stack reaches the stack present sensor
(S32).
Fold unit exit
sensor late
(S31)
The fold unit exit sensor does not go ON after
enough time has elapsed for the stack to feed 1.5
times its length from the fold position.
R8 to
R12
Booklet
Staple
(B700
Only)
Fold unit exit
sensor lag
(S31)
After the fold unit exit sensor goes ON, it does
not go OFF after enough time has elapsed to
feed 442.9 mm.
To Next Page
Loading...
Need help?
General
