August, 2006 DUPLEX UNIT
3-111
3.10.5 DUPLEX JOGGER BELT
Remove:
• Remove the inverter unit (3.10.3)
• Cross stay (3.10.3)
• Reverse trigger roller assembly (3.10.3)
• Jogger fences (3.10.3)
• Left transport cover (3.10.3)
• Duplex jogger motor (3.10.4).
1. If you are replacing the belt, set both jogger fence brackets at the center of the
belt and tighten the screw [A].
2. If you are adjusting the belt, loosen the screw and slide the plastic piece [B] on
the belt to the left or right to adjust the position of the front fence, then tighten
the screw.
To Next Page
Loading...
Need help?
General
