April, 2007 FIRMWARE UPDATE
5-17
5.4.2 DOWNLOADING STAMP DATA
You must download the fixed stamp data from the machine ROM onto the hard
disk after the HDD has been formatted or has been replaced and formatted. Then
these stamps can be used by the system. If this is not done, the user will not have
access to the fixed stamps (“Confidential”, “Secret”, etc.).
1. Go into the SP mode.
1. Select SP5853 then press “Execute”.
2. Obey the instructions on the screen to complete the procedure.
3. Switch the machine OFF and remove the SD card.
To Next Page
Loading...
