April, 2007 ADDITIONAL INFORMATIONS
4-95
Final Solution: Middle Thickness Paper Mode
1. Power Supply Voltage Check when using before applying the final solution.
Check the Power Supply Voltage during the continuous printing. If the power
supply voltage is lower than 220V, change the heating roller lamp2 duty for FC
printing.
SP1108-008 (Htg Roll Lamp2 Norm: FC)
Change to 100 (default: 83)
SP1108-009 (Htg Roll Lamp2 Scan: FC)
Change to 83 (default: 66)
2. Toner Maximum Limitation
If the customer agrees to the toner maximum limitation change, reduce the
value as follows:
• For machines that use a PostScript3 unit type3260 (B761) printer driver:
Set SP1106-001 to a value of 200.
Printer SP
Number
Description
Default
Settings
Final
Solution
NOTE
1106-001 Toner Limit:
Photo
260 200 Toner maximum limitation
for Photo mode.
• For the EFI printer controller (G815: E-7000):
1) Open the "E-7000 PS Document Properties" dialog.
2) Click on the “Fiery Printing" tab, and then select the "Image Quality" option.
3) Change the "Toner Reduction" setting to ON.
To Next Page
Loading...
Need help?
General
