RESETS April, 2007
5-8
5.2.2 SOFTWARE AND SETTING RESET
Software Reset
The software can be rebooted when the machine hangs up.
To do a software reset:
Turn the main power switch OFF and ON.
-or-
Press and hold down [•/] and [#] together for at least 10 seconds.
When the machine beeps once, release both buttons. After “Now loading. Please
wait” is displayed for a few seconds, the copy window will open. The machine is
ready for operation.
Resetting the User Tool Settings
The system settings in the UP mode can be reset to their defaults with this
procedure.
1. Make sure that the machine is in the copier standby mode.
2. Press the [User Tools] key.
3. Hold down the [#] key and press “System Setting” on the display.
4. A confirmation message will be displayed, then press “Yes”.
Resetting Copy/Document Server Features Only
The copy/document server settings in the UP mode can be reset to their defaults
with this procedure.
1. Make sure that the machine is in the copier standby mode.
2. Press the [User Tools] key.
3. Hold down the [#] key and press “Copy/Document Server Features” on the
display.
4. When the message appears, press “Yes”.
Resetting Scanner Features Only
The scanner settings in the UP mode can be reset to their defaults with this
procedure
1. Make sure that the machine is in the copier standby mode.
2. Press the [User Tools] key.
3. Hold down the [#] key and press “Scanner Features” key.
4. When the message appears, press “Yes”
To Next Page
Loading...
Need help?
General
