Toshiba e-STUDIO4500c - Counter Display Setting; Print an SMC Report

August, 2006 COPIER E-STUDIO4500C/5500C
1-35
Installation
Counter Display Setting
The default setting for the counter is "0" (development). Do the SP setting below to
set the counter for copy/print (paper count).
1. Enter the SP mode.
2. Do SP5045 001 (Counter Display Setting).
3. Select the counter to use:
0 Development counter (Default)
1 Page counter
Important!
• T
HIS SETTING CAN BE DONE ONLY ONCE. AFTER IT IS SET TO "1", THE COUNTER
SETTING CANNOT BE CHANGED
. IF THE WRONG SETTING IS SELECTED BY MISTAKE,
CONTACT YOUR TECHNICAL SUPERVISOR
.
Print an SMC Report
1. Enter the SP mode.
2. Do SP5990 001 to print a full SMC report. Keep it in a safe location, with the
factory setting sheet.