April, 2007 ADDITIONAL INFORMATIONS
4-111
3) "Middle Thickness Paper Mode -3"
NOTE: This setting should be selected if the effectiveness of "Middle
Thickness Paper Mode-2" is still not enough for the poor fusing.
However, with this setting, it is easier for separation pawl streaks to
occur.
Change the following SP setting as a set.
a) SP1105-013 (Htg Roll Sn1: Ctr / 1-S: Thk3: FC: NS: CPM)
Change to 190 (default: 180)
b) SP1105-021 (Htg Roll Sn1: Ctr / 2-S: Thk3: FC: NS: CPM)
Change to 190 (default: 180)
c) SP1105-021 (Htg Roll Sn1: Ctr / 2-S: Thk3: FC: NS: CPM
Change to 0 (default: 5)
07/04
To Next Page
Loading...
