Toshiba e-STUDIO4500c - Page 288

August, 2006 FUSING UNIT
3-101
Assembling procedure:
• Attach the fusing belt [L] and hot roller [M].
• Attach the lock rings [I], shaft bearings [J] and gears [K] to the front and rear of
the heating roller.
NOTE: Make sure the bearing flange is on the outside.
• Attach the heating roller [H] (Length [N] > [O]).
• Attach the lock rings [E], bushings [F] and bearings [G] to the front and rear of
the heating roller.
NOTE: Make sure the bearing flange is on the outside.
• Rotate the flame [D] to the left.
• Tight the three screws [A], [B] and [C].
[E]
[B]
[E]
[G]
[G]
[A]
[L]
[M]
[I]
[J]
[I]
[H]
[J]
[K]
[C]
[D]
[N]
[O]
[K]
[F]
[F]