The NetFile file management on the
HDD cannot be used, or a NetFile
management file is corrupted and
operation cannot continue. The
HDDs are defective and they
cannot be debugged or partitioned,
so the Scan Router functions
(delivery of received faxes,
document capture, etc.), Web
services, and other network
functions cannot be used.
HDD status codes are displayed
below:
• Refer to the four procedures below
(Recovery from SC 925).
Here is a list of HDD status codes:
Display
Meaning
(-1) HDD not connected
(-2) HDD not ready
(-3) No label
(-4) Partition type incorrect
(-5) Error returned during label read or check
(-6) Error returned during label read or check
(-7) “filesystem” repair failed
(-8) “filesystem” mount failed
(-9) Drive does not answer command
(-10) Internal kernel error
(-11) Size of drive is too small
(-12) Specified partition does not exist
(-13) Device file does not exist
To Next Page
Loading...
