ADDITIONAL INFORMATIONS April 2007
4-106
2. Turn off the e-STUDIO4500c/5500c main power switch.
NOTE: The Color Controller E-7000 will shut down automatically.
3. Wait for the E-7000 diagnostic LEDs to turn off.
4. Turn off the main power switch of the Color Controller E-7000.
5. Put the firmware SD card into Slot 3 and turn on the e-STUDIO4500c/5500c
main power switch.
6. After the firmware update is finished, turn off the e-STUDIO4500c/5500c main
power switch and remove the SD card.
7. Turn on the e-STUDIO4500c/5500c main power switch.
8. Turn on the main power switch of the Color Controller E-7000.
Main Power Switch
To Next Page
Loading...
