April, 2007 SERVICE PROGRAM MODE
5-3
Button Selection Entry
1. Refer to the SP Mode Tables in this section to find the SP that you want to
adjust.
2. Press the Group number on the left side of the SP Mode window that contains
the SP that you want to adjust.
3. Use the scrolling buttons in the center of the SP mode window to display the
SP number that you want to open, then press that number to expand the list.
4. Use the center touch-panel buttons to scroll to the number and title of the item
that you want to set, and press [#]. The small entry box on the right is activated
and displays the default or the current setting below.
5. To enter a setting
• Press [#] to enter a minus sign. Then use the keypad to enter the
appropriate number. The number you enter will write over the previous
setting.
• Press [#] to enter the setting. (If you enter a number that is out of range, the
key press is ignored.)
• When you are prompted to complete the selection, press Yes.
6. If you need to perform a test print, press "Copy Window" to open the copy
window and select the settings for the test print. Press the [Start] () key twice,
then press "SP Mode" (highlighted) in the copy window to return to the SP
mode display.
7. When you are finished, press "Exit" twice to return to the copy window.
To Next Page
Loading...
Need help?
General
