Toshiba e-STUDIO4500c - Page 55

COPIER E-STUDIO4500C/5500C August, 2006
1-16
5. On the front end of the PCU, remove the shaft cap [A] and lock plate [B] ( x 3).
Important: After you remove the shaft cap, make sure that you do not turn the
shaft [C] of the development roller.
6. On the rear end of the PCU, remove the lock plate [D] ( x 4).
7. Remove the development unit [E] from the PCU.
B132R210.WMF
[A]
[B]
[C]
[D]
[E]