1
The last sheet of the stack [1] enters the stapling tray. The jogger fences [2] jog the
last sheet into position (based on the width of the selected paper size) and then
retract and stop 1 mm away from the sides of the stack.
2
The pressure plate [3] and booklet pressure roller [4] press down on the sheet. The
stack feed out belt switches on and the pawl [5] on the feed out belt catches the
bottom of the stack and raises it. The stapling tray sensor [6] detects the trailing
edge of the paper stack.
3
The feed out belt [7] raises the stack to the prescribed stapling position and stops.
The jogger fences move to the sides of the stack and the booklet staplers [8] staple
the stack.
B700D912.BMP
To Next Page
Loading...
