Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 1 IP Address Configuration Commands
Huawei Technologies Proprietary
1-2
Description
Using display ip interface command, you can view the information of an IP interface.
By default, the information about all the IP interfaces will be displayed if undo interface
is specified. This command outputs all the information related to IP on the interface,
which is useful for troubleshooting.
Example
# Display the information related to interface VLAN-Interface 1.
<Quidway> display ip interface vlan-interface 1
Vlan-interface1 current state : DOWN
Line protocol current state : DOWN
Internet Address is 1.1.1.1/8 Primary
Broadcast address : 1.255.255.255
The Maximum Transmit Unit : 1500 bytes
input packets : 0, bytes : 0, multicasts : 0
output packets : 0, bytes : 0, multicasts : 0
DHCP packet deal mode: global
1.1.3 ip address
Syntax
ip address ip-address { mask | mask-length } [ sub ]
undo ip address [ ip-address { mask | mask-length } [ sub ] ]
View
VLAN interface view or LoopBack interface view
Parameter
ip-address: IP address of VLAN interface.
mask: Corresponding subnet mask.
mask-length: Mask length, i.e. the length of "1" in the IP address.
sub: the secondary IP address of the VLAN interface.
Description
Using ip address command, you can configure an IP address for VLAN or LookBack
interface. Using undo ip address command, you can cancel an IP address of the
VLAN or LookBack interface
By default, all interfaces’ IP addresses are null.
Generally, it is enough to configure one IP address for an interface. You can also
configure 10 IP addresses for an interface at most, so that it can be connected to
To Next Page
Loading...
Need help?
General
