Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-33
time is expressed in the format hh:mm:ss-yyyy/mm/dd. When this parameter is set, all
the stopping accounting requests saved since start-time to stop-time will be deleted.
user-name user-name : Configures to delete the stopping accounting requests from
the buffer according to the username. User-name specifies the username, a character
string not exceeding 80 characters.
Description
Using reset stop-accounting-buffer command, you can reset the stopping
accounting requests, which are saved in the buffer and have not been responded.
By default, after transmitting the stopping accounting requests, if there is no response
from the RADIUS server, the switch will save the packet in the buffer and retransmit it
for several times, which is set through the retry realtime-accounting command.
This command is used to delete the stopping accounting requests from the switch
buffer. You can select to delete the packets transmitted to a specified RADIUS server,
or according to the session-id or username, or delete the packets transmitted during the
specified time-range.
For the related commands, see stop-accounting-buffer enable, retry
stop-accounting, display stop-accounting-buffer.
Example
# Delete the stopping accounting requests saved in the system buffer by the user,
user0001@huawei163.net.
<Quidway> reset stop-accounting-buffer user-name user0001@huawei163.net
# Delete the stopping accounting requests saved in the system buffer since 0:0:0 to
23:59:59 on August 31, 2002.
<Quidway> reset stop-accounting-buffer time-range 0:0:0-2002/08/31
23:59:59-2002/08/31
3.2.17 retry
Syntax
retry retry-times
undo retry
View
RADIUS scheme view
Parameter
retry-times: Specifies the maximum times of retransmission, ranging from 1 to 20. By
default, the value is 3.
To Next Page
Loading...
Need help?
General
