Command Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 1 File System Management Commands
Huawei Technologies Proprietary
1-12
Parameter
None
Description
Using reset saved-configuration command, you can erase configuration files from
the flash memory of the Ethernet Switch.
Perform this command with cautious. It is suggested to consult technical support
personnel first.
Generally, this command is used in the following situations:
z After upgrade of software, configuration files in flash memory may not match the
new version's software. Perform reset saved-configuration command to erase
the old configuration files.
z If a used Ethernet Switch is applied to the new circumstance and the original
configuration files cannot meet the new requirements, the Ethernet Switch should
be configured again. Erase the original configuration files for reconfiguration.
If the configuration files do not exist in the flash memory when Ethernet Switch is
electrified and initialized, it will enter setup switch view automatically.
For the related commands, see save, display current-configuration, display
saved-configuration.
Example
# Erase the configuration files from the flash memory of Ethernet Switch.
<Quidway> reset saved-configuration
This will delete the configuration in the flash memory.
The switch configurations will be erased to reconfigure.
Are you sure?[Y/N]
1.2.2 save
Syntax
save
View
User view
Parameter
None
Description
Using save command, you can save the current configuration files to Flash memory.
To Next Page
Loading...
Need help?
General
