Huawei quidway s3526 series

Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 8 BOOTP Client Configuration Commands
Huawei Technologies Proprietary
8-1
Chapter 8 BOOTP Client Configuration Commands
 Note:
This chapter only applies to S3552G, S3552P, S3528G, S3528P, S3552F, S3526E,
S3526E FM, S3526E FS and S3526C in S3500 series switches.
8.1.1 debugging bootp client
Syntax
debugging bootp client
undo debugging bootp client
View
User view
Parameter
None
Description
Using the debugging bootp client command, you can enable BOOTP client
debugging. Using the undo debugging bootp client command, you can disable
BOOTP client debugging.
By default, BOOTP client debugging is disabled.
Example
# Enable BOOTP client debugging.
<Quidway> debugging bootp client
8.1.2 display bootp client
Syntax
display bootp client [ interface vlan-interface vlan-id ]
View
Any view