Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-34
Description
Using retry command, you can configure retransmission times of RADIUS request
packet. Using undo retry command, you can restore the retransmission times to
default value.
Because RADIUS protocol uses UDP packets to carry the data, its communication
process is not reliable. If the RADIUS server has not responded NAS until timeout, NAS
has to retransmit RADIUS request packet. If it transmits more than the specified
retry-times, NAS considers the communication with the primary and secondary
RADIUS servers has been disconnected.
Setting a suitable retry-time according to the network situation can speed up the system
response.
For the related command, see radius scheme.
Example
# Set to retransmit the RADIUS request packet no more than 5 times for the RADIUS
scheme huawei.
[Quidway-radius-huawei] retry 5
3.2.18 retry realtime-accounting
Syntax
retry realtime-accounting retry-times
undo retry realtime-accounting
View
RADIUS scheme view
Parameter
retry-times: Specifies the maximum times of real-time accounting request failing to be
responded, ranging from 1 to 255. By default, the accounting request can fail to be
responded up to 5 times.
Description
Using retry realtime-accounting command, you can configure the maximum times of
real-time accounting request failing to be responded. Using undo retry
realtime-accounting command, you can restore the maximum times of real-time
accounting request failing to be responded to the default value.
RADIUS server usually checks if a user is online with timeout timer. If the RADIUS
server has not received the real-time accounting packet from NAS, it will consider that
there is line or device failure and stop accounting. Accordingly, it is necessary to
To Next Page
Loading...
Need help?
General
