Command Manual - VLAN
Quidway S3500 Series Ethernet Switches Chapter 1 VLAN Configuration Commands
Huawei Technologies Proprietary
1-9
Example
# Display the protocol information and protocol index configured on Ethernet0/1 and
Ethernet0/2.
[Quidway] display protocol-vlan interface ethernet0/1 to ethernet0/2
Interface: Ethernet0/1
VLAN ID Protocol-Index Protocol-type
50 1 ip 192.168.10.1 255.255.255.0
80 2 ip 101.120.34.0 255.255.0.0
100 1 ip 104.232.43.0 255.255.255.0
100 2 ipx ethernetii
Interface: Ethernet0/2
VLAN ID Protocol-Index Protocol-type
50 5 ipx raw
80 1 at
100 3 mode snap etype 0x0abc
100 5 mode llc dsap 0xac ssap 0xbd
1.2.2 display protocol-vlan vlan
Syntax
display protocol-vlan vlan { vlan-id [ to vlan-id ] | all }
View
Any view
Parameter
vlan-id: Displays the protocol information of the specific VLAN, ranging from 1 to 4094.
all: Displays the protocol information of all VLANs.
Description
Using the display protocol-vlan vlan command, you can view the protocol
information and protocol index configured on a VLAN, to which you can refer when you
use the protocol-based VLAN and add/delete a protocol.
For the related commands, see display vlan.
Example
# Display the protocol information and protocol index configured on the VLANs from
VLAN10 to VLAN20
[Quidway] display protocol-vlan vlan 10 to 20
VLAN ID: 10
VLAN Type: Protocol-based VLAN