Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 2 Portal Configuration Commands
Huawei Technologies Proprietary
2-11
[Quidway] portal method redhcp
2.1.10 portal server
Syntax
portal server server-name { ip ip-address | key key-string | port port | url url-string } *
undo portal server server-name [ key | port | url ]
View
System view
Parameter
server-name: Portal server name, in the range of 1 to 32 characters
ip-address: IP address for Portal server. It cannot be 0.0.0.0, loop address, multicast
address or broadcast address.
key-string: Shared key for communication with Portal server, in the range of 1 to 16
characters. By default, it is huawei.
port: Port from which packets are sent to Portal server, in the range of 1 to 65,534. By
default, it is 50100.
url-string: URL used in HTTP re-directing, which is the IP address in character form. If
an IP address is 10.110.100.100, then its default URL is “http://10.110.100.100”. The
character string must be put between double quotation marks.
Description
Use the portal server command to initiate or modify Portal server configuration.
Use the undo portal server command to delete a specified Portal server or restore the
default configuration for a specified Portal server.
Caution:
z The IP address of Portal server must be configured in the first-time configuration of
the server.
z If you want to modify the parameters of a configured Portal server which is enabled
on a VLAN interface, you must first remove the Portal server from the VLAN
interface.
z The Portal server automatically uses a free IP address. If the number of free IP
addresses reaches the maximum number, the Portal server configuration will fail.
To Next Page
Loading...
Need help?
General
