Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 6 DHCP Configuration Commands
Huawei Technologies Proprietary
6-29
View
DHCP address pool view
Parameter
mac-address: MAC address to be bound.
Description
Using the static-bind mac-address command, you can configure the MAC address to
be used in a static binding. Using the undo static-bind mac-address command, you
can delete the MAC address in a binding.
By default, no MAC address is bound statically.
The commands static-bind mac-address and static-bind ip-address must be used
in pairs to statically bind a MAC address with an IP address.
For the related commands, see dhcp server ip-pool and static-bind ip-address.
Example
# Bind the MAC address 0000-e03f-0305 with the IP address 10.1.1.1 using the mask
255.255.255.0.
[Quidway-dhcp-0] static-bind ip-address 10.1.1.1 mask 255.255.255.0
[Quidway-dhcp-0] static-bind mac-address 0000-e03f-0305
6.3 DHCP Relay Configuration Commands
6.3.1 address-check dhcp-relay
Syntax
address-check dhcp-relay enable
address-check dhcp-relay disable
View
VLAN interface view
Parameter
None
Description
Use the address-check dhcp-relay enable command to activate the dynamic entries
generated by the DHCP relay.
Use the address-check dhcp-relay disable command to deactivate the dynamic
entries generated by the DHCP relay
To Next Page
Loading...
Need help?
General
