Command Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 2 HGMP V2 Configuration Commands
Huawei Technologies Proprietary
2-17
Description
Using build command, you can configure a cluster on a device. The name parameter
specifies the name of the cluster. Using undo build command, you can cancel a
cluster.
By default, all the devices supporting cluster are candidate devices.
After a cluster is created, the device on which the command is executed becomes the
administrator device and will be assigned with a fixed member number of 0.
This command can be executed on an administrator device or a command-capable
device. Using it on an administrator device, you can rename a cluster. Using it on a
candidate device, you can create a cluster.
Example
# Configure the current switch as the administrator device and specifies HUAWEI as
the cluster name.
[Quidway-cluster] build HUAWEI
2.3.5 cluster
Syntax
cluster
View
System view
Parameter
None
Description
Using cluster command, you can enter cluster view.
Example
# Enter cluster view.
[Quidway] cluster
[Quidway-cluster]
2.3.6 cluster enable
Syntax
cluster enable
undo cluster enable