Huawei quidway s3526 series User Manual

Command Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-3
Example
# Display configuration information of Ethernet0/1.
<Quidway> display interface ethernet0/1
Ethernet0/1 current state : UP
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is
00e0-fc00-0010
Description : aaa
The Maximum Transmit Unit is 1500
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not supported
The Maximum Frame Length is 1536
Broadcast MAX-ratio: 100%
PVID: 1
Mdi type: auto
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
Last 5 minutes input: 0 packets/sec 0 bytes/sec
Last 5 minutes output: 0 packets/sec 0 bytes/sec
input(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts
input(normal): - packets, - bytes
- broadcasts, - multicasts
input: 0 input errors, 0 runts, 0 giants, - throttles, 0 CRC
0 frame, - overruns, 0 aborts, 0 ignored, - parity errors
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output(normal): - packets, - bytes
- broadcasts, - multicasts, - pauses
Output: 0 output errors, 0 underruns, - buffer failures
- aborts, 0 deferred, 0 collisions, 0 late collisions
- lost carrier, - no carrier
Table 1-1 Output description of the display interface command
Field Description
Ethernet0/1 current state
The current state of Ethernet port (enabled or
disabled)
IP Sending Frames' Format Ethernet frame format

Huawei quidway s3526 series Specifications

General

Brand	Huawei
Model	quidway s3526 series
Category	Network Router
Language	English