Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-35
disconnect the user at NAS end and on RADIUS server synchronously when some
unexpected failure occurs. Quidway Series Ethernet Switches support to set maximum
times of real-time accounting request failing to be responded. NAS will disconnect the
user if it has not received real-time accounting response from RADIUS server for some
specified times.
How to calculate the value of count? Suppose RADIUS server connection will timeout
in T and the real-time accounting interval of NAS is t, then the integer part of the result
from dividing T by t is the value of count. Therefore, when applied, T is suggested the
numbers which can be divided exactly by t.
For the related command, see radius scheme
Example
# Allow the real-time accounting request failing to be responded for up to 10 times.
[Quidway-radius-huawei] retry realtime-accounting 10
3.2.19 retry stop-accounting
Syntax
retry stop-accounting retry-times
undo retry stop-accounting
View
RADIUS scheme view
Parameter
retry-times: Specifies the maximal retransmission times after stopping accounting
request,. ranging from 10 to 65535. By default, the value is 500.
Description
Using retry stop-accounting command, you can configure the maximal
retransmission times after stopping accounting request . Using undo retry
stop-accounting command, you can restore the retransmission times to the default
value.
Because the stopping accounting request concerns account balance and will affect the
amount of charge, which is very important for both the user and ISP, NAS shall make its
best effort to send the message to RADIUS accounting server. Accordingly, if the
message from the switch to RADIUS accounting server has not been responded, the
switch shall save it in the local buffer and retransmit it until the server responds or
discard the messages after transmitting for specified times.
For the related commands, see reset stop-accounting-buffer , radius scheme,
display stop-accounting-buffer .
To Next Page
Loading...
Need help?
General
