Command Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 1 ACL Commands
Huawei Technologies Proprietary
1-21
Command Function
reset
traffic-statistic
Reset statistic information of traffic. This command is used in
the case of filtering or classifying the data transmitted by the
hardware of switch. Commonly, this command is used to
reset the statistics information of the traffic-statistic
command.
Example
# Clear the statistics information of ACL 2000.
<Quidway> reset acl counter 2000
1.2.7 rule
Syntax
I. define/delete a rule for basic acl
rule [ rule-id ] { permit | deny } [source source-addr wildcard | any ] [ fragment ]
[ time-range name ]
undo rule rule-id [ source ] [ fragment ] [ time-range ]
II. define/delete a rule for advanced acl
rule [ rule-id ] { permit | deny } protocol [ source source-addr wildcard | any ]
[ destination dest-addr dest-mask | any ] [ source-port operator port1 [ port2 ] ]
[ destination-port operator port1 [ port2 ] ] [ icmp-type type code ] [ established ]
[ [ precedence precedence | tos tos ]* | dscp dscp ] [ fragment ] [ time-range name ]
undo rule rule-id [ source ] [ destination ] [ source-port ] [ destination-port ]
[ icmp-type ] [ precedence ] [ tos ] [ dscp ] [ fragment ] [ time-range ]
III. define/delete a rule for link acl
rule [ rule-id ] { permit | deny } [ protocol ] [ cos vlan-pri ] [ ingress { { source-vlan-id |
source-mac-addr source-mac-wildcard | interface { interface-name | interface-type
interface-num } }* | any } ] [ egress { { dest-mac-addr dest-mac-wildcard | interface
{ interface-name | interface-type interface-num } }* | any } ] [ time-range name ]
undo rule rule-id
IV. define/delete a rule for user-defined acl
rule [ rule-id ] { permit | deny } { rule-string rule-mask offset }&<1-8> [ time-range
name ]
undo rule rule-id
To Next Page
Loading...
Need help?
General
