Command Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 2 QoS Commands
Huawei Technologies Proprietary
2-24
Example
# Display the settings of traffic limit.
<Quidway> display qos-interface traffic-limit
Ethernet0/1: traffic-limit
Inbound:
Matches: acl 2000 rule 0 running
Target rate: 10 Mbps
Ethernet0/2: traffic-limit
Inbound:
Matches: acl 10 rule 0 running
Target rate: 100 Mbps
Exceed action: drop
Table 2-15 the display Information
Field Description
Ethernet0/2: traffic-limit
Inbound:
Matches: acl 2000 rule 0
running
Target rate: 4 Mbps
Exceed action: drop
Indicates the traffic-limit configuration of the port.
“Inbound:” indicates system only treats the traffic
received by the port.
“Matches: acl 2000 rule 0 running” indicates the
classification rule to the traffic.
“Target rate: 4 Mbps” indicates the s the normal rate
for the packets matching the classification rule.
“Exceed action: drop” indicates the action to the
traffic which match the classification rule but exceed
the normal rate. The action can be “drop” or
“remark-dscp”.
2.2.10 display queue-scheduler
Syntax
display queue-scheduler
View
Any view
Parameter
None
Description
Using display queue-scheduler command, you can view the queue scheduling mode
and parameters.
To Next Page
Loading...
