Command Manual - Reliability
Quidway S3500 Series Ethernet Switches Chapter 1 VRRP Configuration Commands
Huawei Technologies Proprietary
1-2
1.1.2 display vrrp
Syntax
display vrrp [ { interface | statistics } vlan-interface interface-num ]
[ virtual-router-ID ]
View
Any view.
Parameter
interface-name: Interface name, the interface form is VLAN-interface interface-num.
virtual-router-ID: VRRP virtual router ID, ranging from 1 to 255.
Description
Using display vrrp command, you can view the information about the VRRP state.
This command is used to view the information about the VRRP state and configuration
parameters. If the interface name and virtual router ID are not specified, the state
information about all the virtual routers on the switch will be displayed. If only the
interface name is specified, the state information about all the virtual routers on the
interface will be displayed. If the interface name and virtual router ID are specified, the
state information about the specified virtual router on the interface will be displayed.
Example
# Display the information about the virtual routers on VLAN-interface 1 of the switch.
[Quidway-Vlan-interface1] display vrrp
Run Method : VIRTUAL-MAC Virtual Ip Ping : Disable
Interface : Vlan-interface1
VRID : 1 Adver. Timer : 1
Admin Status : UP State : Initialize
Config Pri : 100 Run Pri : 90
Preempt Mode : YES Delay Time : 0
Auth Type : NONE
Track IF : Vlan-interface2 Pri Reduced : 10
Virtual IP : 1.1.1.1
Master IP : 0.0.0.0
Table 1-2 Description of information generated by the command display vrrp
Field Description
Run Method Run method: real or virtual MAC method
Virtual IP ping Whether to enable to ping through virtual IP
To Next Page
Loading...
Need help?
General
