Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 9 Access Management Configuration Commands
Huawei Technologies Proprietary
9-3
interface-number | interface-name } ] } &<1-10> format. interface-name: Specified the
port name, represented with interface-name= interface-type interface-number.
interface-type is port type and interface-number is port number. For details about
interface-type, interface-number and interface-name, refer to the Port Command
Manual. &<1-10> indicates the preceding parameter can be input up to 10 times.
Description
Using am isolate command, you can configure Layer 2 isolation on a port so as to
prevent the packets from being forwarded on Layer 2 between the specified port and
some other port (group). Using undo am isolate command, you can cancel the Layer 2
isolation on the port.
By default, The isolation port pool is null and the packets are allowed to be forwarded
between the specified port and all other ports on Layer 2.
The port isolation is bidirectional. Isolating the port itself does not make any sense.
Example
# Isolate Ethernet0/1 from Ethernet0/2, and Ethernet0/4 through Ethernet0/7.
[Quidway-Ethernet0/1] am isolate ethernet0/2 ethernet 0/4 to ethernet 0/7
9.1.4 am trap enable
Syntax
am trap enable
undo am trap enable
View
System view
Parameter
None
Description
Using am trap enable command, you can enable the access management trap
function. Using undo am trap enable command, you can disable the access
management trap function.
By default, The access management trap disabled.
Example
# Enable the access management trap.
[Quidway] am trap enable
To Next Page
Loading...
Need help?
General
