Command Manual - VLAN
Quidway S3500 Series Ethernet Switches Chapter 2 Isolate-User-Vlan Configuration Commands
Huawei Technologies Proprietary
2-3
Secondary VLAN is established. The actual operation include: add the ports of
isolate-user-vlan to every Secondary VLAN and add the ports of all Secondary VLANs
to isolate-user-vlan.
After undo command is run, the mapping relationship between isolate-user-vlan and
Secondary VLAN will be canceled. The actual operation include: delete the ports
included in isolate-user-vlan from Secondary VLAN and delete the ports included in
Secondary VLAN from isolate-user-vlan.
For the related command, see display isolate-user-vlan.
Example
# Associate isolate-user-vlan 10 with Secondary vlan2, 3, 4, 5 and 9.
[Quidway] isolate-user-vlan 10 secondary 2 to 5 9
2.1.3 isolate-user-vlan enable
Syntax
isolate-user-vlan enable
undo isolate-user-vlan enable
View
VLAN view
Parameter
None
Description
Using isolate-user-vlan enable command, you can configure the type of one VLAN as
isolate-user-vlan. Using undo isolate-user-vlan enable command, you can cancel the
isolate-user-vlan type of one VLAN.
By default, the type of the VLAN created by the user has not been specified.
isolate-user-vlan can contain many ports, including the uplink ports connected to other
switches. isolate-user-vlan and Trunk ports cannot be configured simultaneously, i.e., if
isolate-user-vlan is configured to the Ethernet switch, the Trunk port cannot be
configured. If the Trunk port is configured, then the isolate-user-vlan cannot be
configured.
For the related commands, see display isolate-user-vlan.
Example
# Configure VLAN 5 as isolate-user-vlan.
[Quidway-vlan5] isolate-user-vlan enable
To Next Page
Loading...
Need help?
General
