Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 2 RIP Configuration Commands
Huawei Technologies Proprietary
2-7
# Set the default cost and import an OSPF route with the default cost.
[Quidway-rip] default cost 3
[Quidway-rip] import-route ospf
2.1.8 network
Syntax
network network-address
undo network network-address
View
RIP view
Parameter
network-address: Address of the network enabled/disabled. It can be the IP network
address of any interface.
Description
Using network command, you can enable Routing Information Protocol (RIP) for the
specified network connected to the router. Using undo network command, you can
disable the RIP on the interface.
By default, RIP is disabled on any interface.
After enabling RIP, RIP at a certain interface must be enabled with the network
command, since RIP works only on the interface of specified network segment. RIP
won’t receive or forward route on interfaces of non-specified network segments.
The undo network command is similar to the undo rip work command in terms of
function. But they are not identical. Their similarity is that the interface using either
command will not receive/transmit RIP routes. The difference between them is that, in
the case of undo rip work , other interfaces will still forward the routes of the interface
using the undo rip work command. In the case of undo network, other interfaces will
not forward the routes of the interface using this command and it seems that the
interface disappeared.
When the network command is used on an address, the effect is that the interface on
the network segment at this address is enabled. For example, the results of viewing the
network 129.102.1.1 with both the display current-configuration command and the
display rip command are shown as the network 129.102.0.0.
For the related commands, see rip work .
Example
# Enable the RIP on the interface with the network address as 129.102.0.0.
To Next Page
Loading...
Need help?
General
