Command Manual - System Management
Quidway S3500 Series Ethernet Switches Chapter 4 System Maintenance Commands
Huawei Technologies Proprietary
4-24
View
System view
Parameter
host-ip-addr: IP address of info-center loghost.
channel: Configure information channel of the info-center loghost.
channel-number: Channel number, ranging from 0 to 9, that is, system has ten
channels.
channel-name: Specify the channel name. The name can be channel6, channel7,
channel8, channel9, console, logbuffer, loghost, monitor, snmpagent,
trapbuffer.
facility: Configure the recording tool of info-center loghost.
local-number: Record tool of info-center loghost, ranging from local0 to local7.
language: Set the logging language.
chinese,english: Language used in log file.
Description
Using info-center loghost command, you can configure the IP address of the
info-center loghost to send information to it. Using undo info-center loghost
command, you can cancel output to info-center loghost.
By default, Ethernet switches do not output information to info-center loghost.
This command takes effect only after the system logging is enabled.
For the related commands, see info-center enable,display info-center.
Example
# Configure to send log information to the UNIX workstation at 202.38.160.1.
[Quidway] info-center loghost 202.38.160.1
4.5.8 info-center loghost source
Syntax
info-center loghost source interface-name
undo info-center loghost source
View
System view
To Next Page
Loading...
Need help?
General
