Command Manual - QoS/ACL
Quidway S3500 Series Ethernet Switches Chapter 2 QoS Commands
Huawei Technologies Proprietary
2-53
Example
# Configure the port Ethernet0/4 as a monitor port.
[Quidway] monitor-port ethernet 0/4 inbound
2.3.21 priority
Syntax
priority priority-level
undo priority
View
Ethernet port view
Parameter
priority-level: Port priority value, in the range of 0~7. By default, it is 0.
Description
Using the priority command, you can configure the local precedence values at a port.
Using the undo priority command, you can restore the default values.
Upon receiving a packet, the switch allocates a service group set to it. The priority value
is allocated according to this: First obtain local precedence value based on “CoS →
Local-precedence” mapping table. If unsuccessful, the local precedence value of
receive port will be used as that for the packet.
Example
# Configure the port Ethernet0/1 with priority value 7.
[Quidway-Ethernet0/1] priority 7
2.3.22 priority trust
Syntax
priority trust
undo priority
View
Ethernet port view
Parameter
None
To Next Page
Loading...
