Command Manual - Security
Quidway S3500 Series Ethernet Switches Chapter 3 AAA & RADIUS Protocol Configuration Commands
Huawei Technologies Proprietary
3-28
Description
Using the nas-ip command, you can set the source IP address of the network access
server (NAS, the switch in this manual), so that all packets destined for the RADIUS
server carry the same source IP address. Using the undo nas-ip command, you can
cancel the configuration.
Specifying a source address for the RADIUS packets to be transmitted can avoid the
situation where the packets sent back by the RADIUS server cannot be received as the
result of a physical interface failure. The address of a loopback interface is usually used
as the source address.
By default, the source IP address of packets is the IP address of the output port.
For the related command, see display radius, radius nas-ip.
Example
# Set the source IP address that is carried in the RADIUS packets sent by the NAS (the
switch) to 10.1.1.1.
[Quidway] radius scheme test1
[Quidway-radius-test1] nas-ip 10.1.1.1
3.2.11 primary accounting
Syntax
primary accounting ip-address [ port-number ]
undo primary accounting
View
RADIUS scheme view
Parameter
ip-address: IP address, in dotted decimal format.
port-number: UDP port number. ranging from 1 to 65535.
Description
Using primary accounting command, you can configure the IP address and port
number for the primary accounting server. Using undo primary accounting command,
you can restore the default IP address and port number of the primary RADIUS
accounting server.
By default, as for the newly created RADIUS scheme, the IP address of the primary
accounting server is 0.0.0.0, and the UDP port number of this server is 1813; as for the
"system" RADIUS scheme created by the system, the IP address of the primary
accounting server is 127.0.0.1, and the UDP port number is 1646.
To Next Page
Loading...
Need help?
General
