Command Manual - Network Protocol
Quidway S3500 Series Ethernet Switches Chapter 1 IP Address Configuration Commands
Huawei Technologies Proprietary
1-3
several subnets. Among these IP addresses, one is the primary IP address and all
others are secondary. The relationship between primary and secondary addresses is:
z When you configure a primary IP address for an interface, which already has a
primary IP address, the newly configured one will replace the old one.
z If you input undo ip address command without any parameter, the switch will
delete both primary and secondary IP address of an interface. undo ip address
[ ip-address { mask | mask-length } command can be used to delete the primary IP
address, while undo ip address [ ip-address { mask | mask-length } sub
command can be used to delete the secondary IP address.
Note that the VLAN interface cannot be configured with the secondary IP address if its
IP address is set to be allocated by BOOTP or DHCP.
For the related command, see display ip interface.
Example
# Configure the IP address of interface VLAN interface 1 as 202.38.10.66 and subnet
mask as 255.255.255.0.
[Quidway-vlan-interface1] ip address 202.38.10.66 255.255.255.0
1.1.4 ip host
Syntax
ip host hostname ip-address
undo ip host hostname [ ip-address ]
View
System view
Parameter
hostname: Name of the host, a character string consisting of 1 to 20 characters,
including letters, numbers, "_", and it must contain at least one letter.
ip-address: Host IP address (the corresponding IP address to the host name) in dotted
decimal notation.
Description
Using ip host command, you can configure the host name and the host IP address.
Using undo ip host command, you can cancel the host name and the host IP address.
By default, Host name and corresponding IP address are null.
For the related command, see display ip host.
To Next Page
Loading...
Need help?
General
