Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 5 IP Routing Policy Configuration Commands
Huawei Technologies Proprietary
5-5
5.1.6 apply local-preference
Syntax
apply local-preference local-preference
undo apply local-preference
View
Route policy view
Parameter
local-preference: New set local preference.
Description
Using apply local-preference command, you can configure to apply the local
preference of route information. This command is one apply sub-statements of
Route-policy attribute set. Using undo apply local-preference command, you can
cancel the apply sub-statement.
For the related commands, see if-match interface, if-match acl, if-match ip-prefix,
if-match ip next-hop, if-match cost, if-match tag, route-policy, apply ip next-hop,
apply local-preference, apply origin and apply tag.
Example
# Apply the local preference level of route information as 130 when this apply
sub-statement is used for setting route information attribute. .
[Quidway-route-policy] apply local-preference 130
5.1.7 apply origin
Syntax
apply origin { igp | egp as-number | incomplete }
undo apply origin
View
Route policy view
Parameter
igp: Set the BGP route information source as internal route
egp: Set the BGP route information source as external route
as-number: Specifies AS number of external route.
incomplete: Setting the BGP route information source as unknown source.
To Next Page
Loading...
Need help?
General
