Command Manual - Integrated Management
Quidway S3500 Series Ethernet Switches Chapter 2 HGMP V2 Configuration Commands
Huawei Technologies Proprietary
2-30
Description
Using snmp-host command, you can configure the public SNMP host for the members
inside a cluster on the administrator device. Using undo snmp-host command, you
can cancel the public SNMP host.
By default, there is no public SNMP host.
This command is used to configure the IP address of the network management site for
the cluster, thereby a cluster member can send the trap information to it via the
administrator device.
Example
# Configure the IP address of SNMP host for the cluster on the administrator device.
[Huawei_0.Quidway-cluster] snmp-host 1.0.0.9
2.3.19 tftp-server
Syntax
tftp-server ip-address
undo tftp-server
View
Cluster view
Parameter
ip-address: IP address of TFTP server configured for the cluster.
Description
Using tftp-server command, you can configure the public TFTP server for the cluster
members on the administrator device. Using undo tftp-server command, you can
cancel the public TFTP server.
By default, there is no public TFTP Server.
Assign an IP address for TFTP server of the cluster, then the member devices can
access the server via the administrator device.
Example
# Configure IP address for TFTP server on the administrator device.
[Huawei_0.Quidway-cluster] tftp-server 1.0.0.9
To Next Page
Loading...
Need help?
General
