Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-47
Description
Using stub command, you can configure the type of an OSPF area as “stub”. Using
undo stub command, you can cancel the settings.
By default, no area is set to be the STUB area.
If the router is an ABR, it will send a default route to the connected stub area . Using
default-cost command, you can configure the default route cost.
For the related commands, see default-cost.
Example
# Set the type of OSPF area 1 to the STUB area.
[Quidway-ospf] area 1
[Quidway-ospf-area-0.0.0.1] stub
3.1.50 vlink-peer
Syntax
vlink-peer router-id [ hello seconds | retransmit seconds | trans-delay seconds |
dead seconds | simple password | md5 keyid key ]*
undo vlink-peer router-id
View
OSPF Area view
Parameter
route-id: Router ID of virtual link peer.
hello seconds: Interval that router transmits hello packet. It ranges from 1 to 8192
seconds. This value must equal the hello seconds value of the router virtually linked to
the interface. The default value is 10 seconds,
retransmit seconds: Specify the interval for re-transmitting the LSA packets on an
interface. It ranges from 1 to 8192 seconds. The default value is 5 seconds.
trans-delay seconds: Specify the interval for delaying transmitting LSA packets on an
interface. It ranges from 1 to 8192 seconds. By default, the value is 1 second.
dead seconds: Specify the interval of death timer. It ranges from 1 to 8192 seconds.
This value must equal the dead seconds of the router virtually linked to it and must be
at least 4 times of the hello seconds. The default value is 40 seconds.
simple password: Specify the simple text authentication password, not exceeding 8
characters, of the interface. This value must equal the authentication key of the virtually
linked peer.
To Next Page
Loading...
Need help?
General
