Command Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-7
undo duplex
View
Ethernet port view
Parameter
auto: Port auto-negotiation attribute.
full: Port full-duplex attribute.
half: Port half-duplex attribute.
Description
Using duplex command, you can configure the full-duplex/half-duplex attribute of the
Ethernet port. Using undo duplex command, you can restore the duplex attribute of
the port to default auto-negotiation mode.
By default, the duplex attribute is auto.
For the related command, see speed.
Example
# Configure the Ethernet port Ethernet0/1 as auto-negotiation attribute.
[Quidway-Ethernet0/1] duplex auto
1.1.7 flow-constrain
Syntax
flow-constrain time-value flow-value { bps | pps }
undo flow-constrain time-value flow-value { bps | pps }
View
Ethernet port view
Parameter
time-value: Time interval to detect traffic on the port, ranging from 5 to 300 (seconds)
and in steps of 5.
flow-value: Traffic threshold on the port, in the range of 0 to 4294967295. It defaults to
0.
bps: Bytes per second.
pps: Packets per second.
Description
Use the flow-constrain command to define traffic threshold on the port.
To Next Page
Loading...
