Command Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-5
Field Description
input(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts
input(normal): - packets, - bytes
- broadcasts, - multicasts
input: 0 input errors, 0 runts, 0
giants, - throttles, 0 CRC
0 frame, - overruns, 0
aborts, 0 ignored, - parity errors
Output(total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts,
0 pauses
Output(normal): - packets, -
bytes
- broadcasts, - multicasts, -
pauses
Output: 0 output errors, 0
underruns, - buffer failures
- aborts, 0 deferred, 0
collisions, 0 late collisions
- lost carrier, - no carrier
The statistics information of input/output packets
and errors on this port
1.1.4 display loopback-detection
Syntax
display loopback-detection
View
Any view
Parameter
None
Description
Using display loopback-detection command, you can view whether the port loopback
detection has been enabled. If it has been enabled, then the time interval of the
detection and the current port loopback information will also be displayed.
Note that S3526/S3526 FS/S3526 FM/S3526E/S3526C Ethernet Switches support this
command in S3500 series switches.
Example
# Display if the port loopback detection is enabled.
To Next Page
Loading...
Need help?
General
