Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 3 OSPF Configuration Commands
Huawei Technologies Proprietary
3-33
View
System view
Parameter
None
Description
Using ospf command, you can enable the OSPF protocol. Using undo ospf command,
you can disable the OSPF protocol.
After starting OSPF protocol, the user can make the corresponding configuration under
the OSPF protocol view.
By default, the system does not run the OSPF protocol.
For the related commands, see network.
Example
# Enable the running of the OSPF protocol.
[Quidway] router id 10.110.1.8
[Quidway] ospf
[Quidway-ospf]
3.1.32 ospf authentication-mode
Syntax
ospf authentication-mode { simple password | md5 key-id key }
undo ospf authentication-mode { simple | md5 }
View
Interface view
Parameter
simple password: Character string not exceeding 8 characters using plain text
authentication.
key-id: ID of the authentication key in MD5 authentication mode in the range from 1 to
255.
key: MD5 authentication key. If it is input in a plain text form, MD5 key is a character
string not exceeding 16 characters. And it will be displayed in a cipher text form in a
length of 24 characters when display current-configuration command is executed.
Inputting the MD5 key in a cipher text form with 24 characters is also supported.
To Next Page
Loading...
Need help?
General
