Huawei quidway s3526 series User Manual

Command Manual - Port
Quidway S3500 Series Ethernet Switches Chapter 1 Ethernet Port Configuration Commands
Huawei Technologies Proprietary
1-11
Slot 7 represents the 1000M Ethernet ports provided by the four GBIC modules on rear
panel respectively and the port number range from 1 to 4.
interface_name: Specifies the port name in the interface_name= interface_type
interface_num format.
Description
Using interface command, you can enter the Ethernet port view.
If the user wants to configure the related parameters of the Ethernet port, he must first
use this command to enter the Ethernet port view.
Example
# Enter the Ethernet0/1 port view.
[Quidway] interface ethernet0/1
1.1.12 loopback
Syntax
loopback { external | internal }
View
Ethernet port view
Parameter
external: External loop test.
internal: Internal loop test.
Description
Using loopback command, you can configure the Ethernet port to perform the
loopback test to check whether the Ethernet port works normally and the loop test will
finish automatically after being performed for a while.
By default, the port will not perform the loopback test.
Example
# Perform the internal loop test for Ethernet0/1.
[Quidway-Ethernet0/1] loopback internal
1.1.13 loopback-detection control enable
Syntax
loopback-detection control enable

Huawei quidway s3526 series Specifications

General

Brand	Huawei
Model	quidway s3526 series
Category	Network Router
Language	English