Command Manual - Routing Protocol
Quidway S3500 Series Ethernet Switches Chapter 4 BGP Configuration Commands
Huawei Technologies Proprietary
4-43
View
BGP view
Parameter
None
Description
Using reflect between-clients command, you can configure the between-client
reflection of a route. Using undo reflect between-clients command, you can disable
this function.
By default, the reflection between clients is enabled.
For the related commands, see reflector cluster-id, peer reflect-client.
Example
# Disable the reflection between clients.
[Quidway-bgp] undo reflect between-clients
4.1.52 reflector cluster-id
Syntax
reflector cluster-id { cluster-id | address }
undo reflector cluster-id
View
BGP view
Parameter
cluster-id: Specify the cluster ID of the route reflector with the range from 1 to
4294967295.
address: Used as the interface address of the route reflector’s cluster ID.
Description
Using reflector cluster-id command, you can configure the cluster ID of the route
reflector. Using undo reflector cluster-id command, you can delete the cluster ID of
the route reflector.
By default, each route reflector uses its Router ID as the cluster ID.
For the related commands, see reflect between-clients, peer reflect-client.
Example
# Set the cluster ID of the route reflector as 80.
To Next Page
Loading...
Need help?
General
